After a year of sitting, our polyester resin had spoiled. So we contacted some people and they said you could do it with just about any medium cure time epoxy. Out into the proper disposal container for petro-chemical waste. Yeah, I went there. Off to the local hardware shop for some epoxy. We bought several batches of 60 min epoxy. Some of the information that our friends told us suggested that we could use isopropyl alcohol to help keep the viscosity of the epoxy down as it is laid up.
Information like this is when it gets exciting. We found out a few things. You can paint the alcohol onto a layer to help flow the epoxy and to reduce the bubbles and flatten wrinkles. I would suggest that pour some alcohol into a cup and paint it on where you need it. Each layup will be different so it is hard to say where you would have issues.
There were some bubble generators in the seam where the semi-mold met the backing. This is probably pretty obvious, but it was due to training air under the resin laden cloth. Our mold also had several regions with nearly perpendicular sections which were hard to wet. In areas like that, I would suggest liberally pre-painting. Be careful not to pool the resin in the bottom since that is not where you want the part to be strong. Another observation was to make sure that when each layer is put down, both people should work in the same direction. Do not work the resin from the nose and the tail. It makes wrinkles and other defects.
It is very important to make sure that each layer has as much of the resin out, or at least even distributed as possible. This means that all of the bubbles, wrinkles and puddles need to be worked toward the edge of the layup. A roller and brushes are the weapons of choice for this work. The handle edges are great for wringing out excess resin from tight radii.
Buzz Labs' unmanned vehicle blog and cool DIY remote controlled stuff blog. For techies by techies, maybe also some interesting tidbits about small business and international business.
Follow us on : 
